• Easy, quick installation
• Will not allow your drip emitters to shift position
• Longer lasting than anything else in the field
• Not effected by UV radiation or temperature

 

The Spring Clip installs quickly and easily to drip wire - in about half the time needed to install other drip line holders.

The Spring Clip will not allow the drip tube to move along the wire. Tight-fitting Spring Clip holds both wire and tube firmly in place retaining the emitters positions along the drip line.
 

The Spring Clip will last longer. Made from .025" thick high carbon spring steel, the Spring Clip will outwear and outlast any plastic clip.  The Spring Clip is unaffected by UV radiation or temperature - it holds its position on the wire as securely in full hot sunlight as in cold weather.
 

A product of AgriClip 
                   Patent Pending 

Hold the Spring Clip between your thumb and forefinger and apply to the wire at about a 30º angle.

Pushing from the top, swing the Spring Clip level and it will snap onto the wire.

Pull the Spring Clip open with your thumb while pulling the tube down  into the clip. 

The Spring Clip is anchored securely to the wire and will not allow the tube to shift position.